Geeetech

yes, Waiting for your good news!

hi mike99ca
sorry for later reply, I read your post, I quite agree with the way you use new products, The way we use may help to other new users
All your operation is correct, now my suggestion is that you should be in all caps to try again.
If you have other questions, please feel free to contact ...

Dear lloyd059
sorry for later reply, Because I rest for three days,The method, I give you can solve most of the leaking problem.
also I have communicate with our engineers about your product material leakage problem, Your question is relatively special
Perhaps is a larger gap between the screw ...

Dear saaxomphone
sorry to late reply, Because thermistor is small, not easy to find, you check your package carefully and the ground.
If you still can't find, you can send a picture of your packaging, we will give you a satisfactory answer.
waiting for your repely, thank you. Best regards!

I reply you another post, thank you!

Hi lloyd059
I'm sorry to appear this kind of phenomenon, I checked photos carefully your provide.
I think the hotend leak a lot Maybe due to no tightening between 1 and 2, Refer to the attached figure.
so I suggest you clean up the leak, tightening between 1 and 2, Then, I think it will work ...

Hi saxomophone
Please refer to the following link. the electronic parts connect.
http://www.geeetech.com/wiki/index.php/Ramps1.4
The appended drawings have a clear connection.thank you.
Best regards!

Hi jafarin
Are the baud rate of GPRS communication and simulation of serial port communication rate consistent?

Hi observing
Thank you very much for your sharing, I think it will help more users, when they encounter similar problems,
Thank you for your support to us，At the same time we will do better，thank you !
Best regards!

Hi, rwyman
I haven't using the SPCE61a based voice recognition module,
but I can help you on the basis of the arduino voice recognition module, if you are interested.
Best regards!