Geeetech

where dos it come from and how long will the order take to get to Canada?
Order NO:20200421015500450 Order Time:2020-04-21 01:55:00
No Idea why it's showing the 21-04-2020 when I ordered it on 20-04-2020...
but this has not shown me an estimated delivery time....
are you guys in Germany??

Im having the exact opposite problem. After bed leveling the first 2 layers print fine but then its as if the Z-Axis is not raising fast enough. Ive sent the G code but no change. I have the M8 threaded rod. Please advise

sounds like you need to calibrate your e steps for your X,Y,Z and make ...

Important tips
1 Always Level the bed hot before your first print.

2 always make sure your extruder is pushing out the correct amount of plastic and set your filament size to 1.75mm by Default in your firmware

3 perform a M303 Auto Temp E0 "M303 E0 C8 S200 and Bed " M303 E-1 C8 S90" add those ...

Ok I have been kicking around the 3D print Community since 2010 and I finally got a Woody on Amazon.ca.
I have had a Persa Mendel/Mono/3II a Hyper Cube XD and a TEVO Tarantula..
so I am no stranger to tweaking Marlin/Sprinter firmware.
so Any suggestion as to what to add to my Woody would be ...

looks like you have the Nozzle set too low, the plastic is backing up in the nozzle set your z to 0.3mm and set the range between 0.2 mm and 0.3mm make sure you purge the Nozzle before you start you may also have a clogged Nozzle... Dust and Dirt that gather on the filament will cause Nozzle ...