Hello all,
I have a question about the temperature sensor in the MK8 extruder.
I can't seem to get it working with RAMPS 1.4. And the Marlin firmware.
In the software Pronterface i can connect and It gives a temperatue of 499 degrees Celcius. And the heater is OFF and not connected. The value is ...
Search found 2 matches
- Fri Oct 17, 2014 5:06 pm
- Forum: Firmware
- Topic: 3D Printer extruder temperature sensor
- Replies: 1
- Views: 7663
- Fri Oct 17, 2014 5:03 pm
- Forum: Stepper Motor
- Topic: 3D Printer extruder stepper motor
- Replies: 3
- Views: 8123
3D Printer extruder stepper motor
Hello all,
I have a question about the MK8 extruder.
The item description says that the stepper motor runs at 6 Volts. But the problem is that all my other steppers are running on 12 Volts. So i would overload the setepper for the extruder and might damige it. i"m using RAMPS 1.4. Is the best ...
I have a question about the MK8 extruder.
The item description says that the stepper motor runs at 6 Volts. But the problem is that all my other steppers are running on 12 Volts. So i would overload the setepper for the extruder and might damige it. i"m using RAMPS 1.4. Is the best ...