Geeetech

Thanks. Im sure it will. I will test it tomorrow.

Ok. Heres pictures of the board and the printer itself.

My printer was working just fine until extruder motor stopped working completely. All it was doing was small back and forward movement, not extruding at all.
I ordered new motor for extruder from geetech but it came with different wire order ...

Please could i have firmware for Me Creator . My email is sierrabar@hotmail.com

Where can i check my mainboard? Printer is basic MeCreator bought from dx.com. I think it has newest Sanguinololu board.

Is there MeCreator firmware somewhere available for download? I've tried using newest marlin but it has too much configurations needing adjusting for mecreator (extruder temps are off etc...). I just needed to invert my extruder direction.