Search found 5 matches

by cds5104
Mon Mar 02, 2015 11:00 pm
Forum: Others
Topic: MIN TEMP err on start up
Replies: 8
Views: 12437

Re: MIN TEMP err on start up

Can I have the original configuration file emailed to me, the system is now not responding to the application. I got reading from the extruder, and completed a dry run print, however when I went to start a print on Saturday morning the system would not respond to the application. It connects, I am ...
by cds5104
Sun Mar 01, 2015 3:24 am
Forum: Others
Topic: MIN TEMP err on start up
Replies: 8
Views: 12437

Re: MIN TEMP err on start up

Can you PM the original configuration file, I was getting somewhere with it, got rid of the MIN temp, and end stop problems, but now I turned it on this morning and it isnt executing any commands. It connects, I am able to upload to it, but it does not execute any manual movements or g code scripts.
by cds5104
Wed Feb 25, 2015 6:33 am
Forum: Others
Topic: MIN TEMP err on start up
Replies: 8
Views: 12437

Re: MIN TEMP err on start up

As far as board, it is using a Ramps 1.4, and in terms of setting anything in the firmware, up to this point I have not touched anything in the firmware. I am about to look into it, and if this is running just an arduino mega type of board then yes I am ready to upload firm ware.
by cds5104
Mon Feb 23, 2015 10:20 pm
Forum: Others
Topic: MIN TEMP err on start up
Replies: 8
Views: 12437

Re: MIN TEMP err on start up

I figured the MIN TEMP out, the thermistor connection, it is reading it off of T2 instead of T0. However I have another issue, I am getting end stop errors, specifically "echo: endstops hit" on every axis despite being centered. I also have no home position movement.
by cds5104
Thu Feb 19, 2015 10:25 am
Forum: Others
Topic: MIN TEMP err on start up
Replies: 8
Views: 12437

MIN TEMP err on start up

I am getting a MIN TEMP error for the nozzle on start, I have checked the connection to the ramp board (swapped it with the hot bed, changed the connector orientation, etc ), unplugged, and shorted the pins using a jumper, it always reads MIN TEMP. When I read the voltage at the thermistor it is at ...