Geeetech

I own a business so I can understand that, I will just have to order the place and wait for it too arrive.

I just have to restart the computer every time I print to fix the first issue. But I will take a video tomorrow to show what's happening.

As for the filament so the reason pla wasnt sent was that there was only ABS?

2125

Www.3dprinteronlinestore.com

My printer was running perfect. Completely perfect. Got it calibrated down to the millimeter.

Did an absolutely perfect print. Then I went to do the SAME print again. This time it went to the same starting point, began to extrude like it should. But continued extruding until it began to grind ...

I have the same extruder and I had to rotate the trimpot on the driver board for the extruder. About a half turn from where it was by default. Also make sure you loosen off the bolt holding that tightening bracket up a bit for abs printing.

I unplugged the motor and plugged it back in and it magically decided it would work now.

I adjusted the trimpot on the extruder driver and it seems to work better. But now my X axis does the skipping. Jumps and whines a bit before giving up.

PLA, my nozzle is supposedly 0.4 and my filament is 1.75

I finally got my prusa i3 to print. It was terrible to watch but it did work. Mostly.

Regardless of whether the extruder clam bolt is all the wya down up, or anything in the middle. If I get to an infill area the extruder begins to "skip" it stops pushing out filament.

Considering it can in areas ...

For some reason it never occurred to me to check how the thermistor had been attached to the heating bed. the wire was wrapped together all the way up. It works now. Thanks a TON!!!