Geeetech

I finally got my machine to work correctly but only after completely disconnecting all stop switches and then crimping the connectors to make sure all wires to the switches and the board had solid contact. I don't know exactly why this worked but I was able to run a complete program and finish my ...

to cazuroweste;
When I put my machine together, I had the same binding problem and fixed it by reaming the 2 holes on the top plates that the Z drive screws go through. The holes were tapered slightly causing the lead screws to bind. You don't want to go over the size they are supposed to be, just ...

In my case, the axis' will move in whatever increment is chosen when in manual mode. It will move the entire length of travel if you tell it to but ONLY in a positive direction.
When I run a program in "dry run", it will do all the positive moves correctly until it runs out of travel, ignoring all ...

My board type is Saguinololu. I was able to make it work one time running a program in "dry run" but when I tried to run with the heats on, it went back to only moving positive. That was the one and only time it worked. Now it only moves positive again whether in setup, dry run, or full run. Other ...

All axis will only move in the positive direction. This is true whether in manual setup or trying to run a program. When in setup, you can move the axis in any increment in a positive direction but then the position resets to 0 and it won't move back. When trying to run a program, I can see the ...