Geeetech

hello..i know im bothering u..but im still struggling to get my sanguinololu 2560+ramps 1.4 printer board to initialize..i going online to see videos and its not helping..The firmware u sent me does not appear in the boards selection..i saved it on adruino hardware..i open adruino hardware and it ...

where do I save sanguine..I pasted the sanguine file in the adruino hardware..i followed the instruction but its not appearing on the boards selection list..Am I saving it wrong?

IM LOOKING FOR THE BOARD TYPE ON MY ADRUINO ("Sanguino W/ATmega1284p 16mhz) AND I CANT FIND IT...I PASTED THE SANGUINO FOLDER IN THE ADRUINO HARDWARE FOLDER..NOW WHEN I GO TO THE BOARDS SECTION AND LOOK FOR THE BOARD TYPE ITS NOT THERE..WHAT AM I DOING WRONG?

I don't know if im doing this right..On adruino..when I hit the upload button..it says compiling sketch..Then I see the upload bar..Then it says upload finished..

This is what I see at the bottom of adruino..It says


Binary sketch size 52,348 bytes (of a 258,048 byte maximum)
avrdude: stk500v2 ...

i see..I guess i need the proper firmware then..If you could kindly e-mail it to me at kalelpuskas@yahoo.com..And if you have a step by step guide on how to install and set up my controller board i would appreciate it..

this is where I got the firmware from... http://www.geeetech.com/wiki/index.php/ ... et_Started

Hello..Im having problem on how to programme my motherboard for the printer..I downloaded everything and cant seem to get it right..i tried downloading the driver but it says the driver is signature enforcement ..so my computer wont download it and when I plug the usb from the printer I hear a noise ...

im using a sanguinololu (standard) mega 2560+ramps 1.4 printerboard..it works with lcd2004 controller..im using acrylic geeetech i3 pro 3d printer..

im using a sanguinololu (standard) mega 2560+ramps 1.4 printerboard..it works with lcd2004 controller..im using acrylic geeetech i3 pro 3d printer..

hello..Its a Sanguinololu (standard) Mega2560+Ramps printerboard..It works with the lcd2004 controller..im using the Acrylic Geeetech i3 pro 3d printer..