Geeetech

1) motor is good
2) driver is good
3) I reinstall again the firmware
4) i dont change the power of drivers because i test it with the driver of z axis and x axis and always have the same problem
5) the cable its ok too, i test it with other cable. About the the board if it had some defective do you ...

I reinstall the firmware and already put the i3 B firmware, but keep the same problem.

I tested too change the motor of Y axis but stayed with the same problem...

I really don't know what´s happened with this...

Hi,

I have a I3 pro C and I already print some parts on my printer in the past. Now, when I need to print another pieces when I start the printer today, when I do autohome the Y axis start moving extremely fast and doing much noise on moves.

So I would like to know what´s happening with the ...

Hi,

Recently I bought a Geeetech PRO C, and the printer comes with a dual extruder pre-mounted, and in my first try to print with the 2 extruders, I try to level the bed, but the distance of each extruder to the bed is different.

I already try to put the extruders on same distance but the printing ...