Geeetech

Thanks. I reversed the black connector & now it moves fine.

Hi again,
I am able to home X & Y axes but the 2 Z motors rotate in opposite directions with one turning left & the other right. How do I remedy this?

Thanks.

I managed to get the LCD screen to display & the X & Y axes to home. My going down is binding up on one side so I need to make some physical adjustments.

Thanks.

I will try the LCD screen swap but what about the lack of movement in the motors + no heat being generated by the Extruder & Bed?

Thanks.

Hi,
I just received a black acrylic i3 prusa with Sanguinololu. I have wired it up, it powers on with fans running & a red light on the board but the LCD panel doesn't display at all.

I have added the specialized firmware, added the USB drivers, & it is seen by Repetier-Host.

In Repetier-Host ...

Hi,
I just built the i3 Pro B & I installed the RepetierHost program with out issue but cannot seem to get the USB Drivers to work. I am using Windows XP & I receive the Found New Hardware notice but it says a problem occurred during installation etc.

I tried to manually install the driver as a ...