Search found 23 matches
- Wed Mar 16, 2016 2:31 am
- Forum: Mods And Hacks
- Topic: Z motors dont move up when printing(M8x2mm leadscrews).
- Replies: 13
- Views: 25939
Re: Z motors dont move up when printing.
ok this is the kind of I have .. M8 x 2 Trapezoidal thread ..im going to do some more search on how to set it up??
- Sun Mar 13, 2016 4:39 am
- Forum: Mods And Hacks
- Topic: Z motors dont move up when printing(M8x2mm leadscrews).
- Replies: 13
- Views: 25939
Re: Z motors dont move up when printing.
Not much of a guide?? Where In the firmware do I find this or how do I adjust it
/
/
/
/
- Fri Mar 11, 2016 9:52 am
- Forum: Mods And Hacks
- Topic: Z motors dont move up when printing(M8x2mm leadscrews).
- Replies: 13
- Views: 25939
Re: Z motors dont move up when printing.
One of my rods bent so I bought 2 of these will that make a difference??
- Wed Mar 09, 2016 10:29 pm
- Forum: Mods And Hacks
- Topic: Z motors dont move up when printing(M8x2mm leadscrews).
- Replies: 13
- Views: 25939
Re: Z motors dont move up when printing.
yes the homing is good everything homes good all motors except the z axis wont move up when printing..??
- Wed Mar 09, 2016 1:21 pm
- Forum: Mods And Hacks
- Topic: Z motors dont move up when printing(M8x2mm leadscrews).
- Replies: 13
- Views: 25939
Z motors dont move up when printing(M8x2mm leadscrews).
I have a geetech Acrylic i3 with the GT2560 board I put the I3X single extruder firmware. Everything works except when i go to print the Z motors don't move up as it is printing they just stay at one layer and don't move UP...pleas any HELP..??? thanks.
Re: firmware
also it wont print in the center, it prints on the side of the bed???
Re: firmware
I did all that ,now my prints come out real small?? I did not change anything in Repetier as it was working great with the other board.
firmware
Hello I have a Prusa Reprap Acrylic i3 it had a sanguinololu board but now I want to replace it with a GT2560 board ...what firmware should I flash the Gt2560 to work with the printer ??? please help....Thanks.
- Fri Dec 11, 2015 12:37 pm
- Forum: Others
- Topic: Mosfet problem
- Replies: 37
- Views: 44447
Re: Mosfet problem
No the MOSFET is fried...Not working...check everything ...everything works except the hot bed!!! Just bought this in May 13, 2015 ....Cant believe it just fried like that,,,Damn!!
- Fri Dec 11, 2015 6:44 am
- Forum: Others
- Topic: Mosfet problem
- Replies: 37
- Views: 44447
Re: Mosfet problem
The Heat bed stopped working and then I looked at the board and this is what it looks like and the heat bed reading in pic 2.