Geeetech

I had the printer for about a year now and i finally got it set up to the point where it prints well. but every print at a certain height it moves few mm to the left and then come back to its original spot. this has been the save with every print when the Z axis is at a certain spot it moves and ...

I have both 1.0.1 and 1.6.2 (I got board installed on this version turns out there was a way) and yes I unzip the U8glib folder which contains two more folders and a couple of other files to libraries in audrino. Like I said I can compile marlin 1.0.2 no problem jus the firmware I got emails have ...

Yea I did the fifth like in the beginning lol I've done it on a reprap before but never had the problem it's still the same error but I do have U8glb file in the libraries folder idk what else is wrong like I said the firmware I get the original marlin 1.0.2 works fine after I edit it compiles well

followed it to a t and still getting this error. like i said i did the same changes and compiled the marlin firmware i got from them but o the one i got from geetech even the ramps one couldnt compile

this is the error


In file included from /dogm_lcd_implementation.h:38,
from ultralcd.cpp:36 ...

its the same as the one i attached. but ihave the ramps board and i managed to get the firmware from marlin working good even the lcd butte firmware i got emailed woks fine with the way it is but when uncomment #define REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER . it will not compile keps giving ...

not quite sure which one but its the big smartlcd and thank you

can i get the firmwarefor the sanguinololu please to enable the ful bigger lcd all i have to do is remove "//" next to it ?

thanks a lot can i use the same on the sanguinololu board i couldnt figure it out so i put the old board back in but i want to use the full graphic display thanks

What is the value of the thermistor on the hotend is it a 10k or 100k
Thanks