Hello Sorry for not getting back with you in a while I have been rather busy with other items. I have taken several pictures of the main board wireing but it is a bit hard to see everything. I hope these help.
http://i.imgur.com/Yvljo7lh.jpg
http://i.imgur.com/Bqjiq1xh.jpg
http://i.imgur.com ...
Search found 3 matches
- Thu Jul 02, 2015 2:59 pm
- Forum: Software
- Topic: Extruder motor
- Replies: 5
- Views: 9894
- Thu Jun 18, 2015 11:02 pm
- Forum: Software
- Topic: Extruder motor
- Replies: 5
- Views: 9894
Re: Extruder motor
Below is the diagram that I used to wire up the componets correctly. I connected the extruder fan near the 11A connection on the 2 pin header.
- Fri Jun 12, 2015 4:07 am
- Forum: Software
- Topic: Extruder motor
- Replies: 5
- Views: 9894
Extruder motor
Ok so I have assembled my printer about 2 months ago and have yet to get it to print anything.
Several background problems.
1. I was never sent the right parts. I was sent substitute parts that are very conflicting with the instructions. ( ramps v4 )
Because of this many things were not wired ...
Several background problems.
1. I was never sent the right parts. I was sent substitute parts that are very conflicting with the instructions. ( ramps v4 )
Because of this many things were not wired ...