Geeetech

I already did all those things all stepper works well on X motor port but no one works on E motor port and all the test were done at extruder temp 210 and bed 95

ok I tried too on X motor with filament and it's ok it works on X motor in manual mode but not on E motor

on the x motor test no filament but with the calibrating pattern on the E motor yes there was filament in it and it did the pattern correctly but nothing came out of the extruder on the E motor. Tried to move the extruder on manual position with option E extrude and E extract with no filament at the ...

1. I tested on x motor drive and it move fine no problem
2. I upgraded the firmware too it's ok
3. The original PSU is defective had to replace it with an old one I had here and it's working
4. the temperature of the extruder heat up to 210 degres and the bed to 95 degres no problem and it did the ...

the temperature when I tried it was at 210 for the extruder and 95 for the table

received it 5 days ago, many bugs on pdf file (bad plug locations) and at the first power up the power supply fuse burn out so replace it and unplug the board cable from de power supply then 2 other fuses burn out so I replace the power supply with an old one I had here now it's working with many ...