I'm glad to hear that, but what am I suppose to do with that problem??Eric wrote:hi,we have improve what you mention in the post ,please pay attention to our new delta rostock mini.Thank you for your advice.
Search found 4 matches
- Fri Jul 10, 2015 1:28 am
- Forum: Assembly
- Topic: Bad crafted parts
- Replies: 7
- Views: 12972
Re: Bad crafted parts
- Tue Jul 07, 2015 12:37 pm
- Forum: Assembly
- Topic: Bad crafted parts
- Replies: 7
- Views: 12972
Re: Bad crafted parts
it is not about rod nut. it is about rod-end bearing holder which is longer than bearing hole, see cross section:
- Tue Jul 07, 2015 11:27 am
- Forum: Assembly
- Topic: Bad crafted parts
- Replies: 7
- Views: 12972
Bad crafted parts
Delta Rostock Mini G2 with GT2560
bolt cannot hold rod firmly because rod-end bearing holder is longer for about 1mm. This happened for all rod-end bearing holders
bolt cannot hold rod firmly because rod-end bearing holder is longer for about 1mm. This happened for all rod-end bearing holders
- Tue Jul 07, 2015 10:34 am
- Forum: Others
- Topic: Auto-leveling problem and broken spider
- Replies: 1
- Views: 4513
Auto-leveling problem and broken spider
Hi,
I have Delta Rostock G2 mini. After proper setup I ran auto-leveling routine using G29 command. It went normally for the first 4 or 5 measuring points, but then Y axis alone started to slowly move down and broke one of spider's mount (see attached picture).
Can I have a replacement? Also I'd ...
I have Delta Rostock G2 mini. After proper setup I ran auto-leveling routine using G29 command. It went normally for the first 4 or 5 measuring points, but then Y axis alone started to slowly move down and broke one of spider's mount (see attached picture).
Can I have a replacement? Also I'd ...