Geeetech

Would it not be more convenient to have all the firmware for all your printers and or products listed in your web site or wiki under support/downloads?

You are selling Open Source printers, so why all the control with the software?

It's not like what you are selling is proprietary. Heck even your ...

Can I get the Firmware for the I3 Acrylic with the 2560 White Board for Dual Extruder?

Thanks

I have read through this board.

I followed the instruction of one of the posts.

I verified the Driver Board voltage at the screw to be 1.0v, it was .858.

After this the extruder motors still did not work.

I moved the driver from extruder 0 to x motor and the x motor moved fine.
I moved the ...

I am having the same problem.

Neither extruder will work.

I swapped the stepper driver with the x motor and both drivers are ok, the x motor moves when i replace it every time.
I checked the voltage to the screw, it was .858, i adjusted it to 1.05 on all stepper drivers.
Neither Extruder motor ...