Geeetech

Update:

I have found the ball bearing that fits the printer belt.
http://www.banggood.com/GT2-Synchronous-Wheel-3MM-Without-Teeth-For-3D-Printer-Accessories-p-1013245.html?p=9R09143243493201512Z
You will need 2 screws from bag #27 ( M3x20mm ), and 2 Hex Lock nut from bag #13 ( Hex Socket nuts M3 ...

Hi Eibsen.

Can you please share the Marlin code that you have used for the auto level to run your board?
What changes did you make to use PB7 as your PWM for the servo?

Thanks.

Hi.

Where can I buy this wheel and MR84zz ball bearings?


also, where can I find the top extruders?


Thanks.

Hi.

Where can I buy the Nema17 split wire? This is the same as the one that comes in the Acrylic Geeetech I3 printer for the Z-Access.
I want to split the signal from one driver to two motors.

Thanks.

Found it:

http://www.geeetech.com/forum/viewtopic ... 18&t=16259

Hi.

The new software from the site had the same bug. I had to change it and remove the filament settings. Now it works without any problem. Im attaching the code im using now.

Hi.

The new software from the site had the same bug. I had to change it and remove the filament settings. Now it works without any problem. Im attaching the code im using now.

Hi.

Here is my design for the extruder fan and auto bed servo:
http://www.thingiverse.com/thing:966244

Now Im only missing the schematic...

Thanks.

Hi.

Can I please have the schismatic of the GT2560 board? I want to add auto calibrate for the bed and I want to use 1 of the free connectors that I have on the board. I need to see how the board is connected so I can find the right connector and change the software to accommodate for the change ...

Hi.

I have ".net framwork 4.0".
If I install the software in a clean directory and not under the GEEETech directory it works fine. Its only if I overwrite the original installation directory that its not working.

Please advise.