Geeetech

HI,

I go through the set up procedure and everything was fine until G29 auto leveling

i do a G28 command , fine

then when i ask a G29 auto level
head go down (half height) then start to move in 16 different location
but going solely up between each point:
going to a point , move up, another point ...

Thanks a lot...

Tip for mac users:
don't use others versions than arduino 1.0.5, to upload firmware
even if you have ftdi drivers installed, be sure to update to the last one

HI,

need to modify firmware for a gt2560 on a g2 delta (to change radius)

where i can download it ?

thanks

Hi,

I face a lot of serial communications errors ,
sometimes i have 5 minutes with no problems then too much errors (resend or wrong commands or n 'waiting commands) to use the printer
don't know what to do

i checked serial speed/stop bit/parity: 250000/1/no
cache size 63

i tested change of usb ...