Also, when I put down the probe, I do not get the
x_max: TRIGGERED
y_max: TRIGGERED
z_min: OPEN
z_max: TRIGGERED
Instead I get
x_max: TRIGGERED
y_max: TRIGGERED
z_min: TRIGGERED
z_max: TRIGGERED
The probe is pressing down on the endstop so I assume there is nothing wrong with the setup. I ...
Search found 3 matches
- Fri Jul 17, 2015 12:47 pm
- Forum: Firmware
- Topic: Need G2S Dual Extruders Firmware
- Replies: 8
- Views: 15778
- Fri Jul 17, 2015 12:20 pm
- Forum: Firmware
- Topic: Need G2S Dual Extruders Firmware
- Replies: 8
- Views: 15778
Re: Need G2S Dual Extruders Firmware
Hi Eric, I didn't receive any attachment for the firmware
- Sun Jul 12, 2015 1:05 pm
- Forum: Firmware
- Topic: Need G2S Dual Extruders Firmware
- Replies: 8
- Views: 15778
Need G2S Dual Extruders Firmware
(1) May I have the firmware for G2S dual extruders? I read through some of the posts in this forum that it is not necessary to alter the firmware, but according to the instruction here it is required for fine-tuning.
(2) I tried to home using the Repetier Host, but the y endstop doesn't get pressed ...
(2) I tried to home using the Repetier Host, but the y endstop doesn't get pressed ...