Geeetech

Hi Mark, I do not get values for x and y axis when I manually move my z-axis using repetier. I only get the value for my z-axis. From the picture you've shown I should be looking at screen on the repetier.

Move the z-axis manually? Using the repetier host controls or the LCD controls of the G2? I do not get any x and y values showing on my lcd but if I do I just wanna know how to proceed. My hotend still hits the bed when I try to send command G29 and nearly scratches if i dont turn it off in time.

Hello,

I am trying to get my printer to print and cannot seem to despite my best efforts. I have finished building, I have measured and found the height of my z-axis but after these steps nothing else seems to be intuitive.

I know the height of my printer, which I have put into the firmware ...

my printer reads 200c for the hot end and 60 for the bed.

Hi Mark,

I examined the wires and was able to fix it I think, I was able to head the extruder and got the servo to move the filament up and down using the LCD controls on the G2, however, I cannot seem to be able to print, I did not receive an endstop for my hotend nozzle but customer service ...

Hello,

I have finally gotten everything to work and set up, however, I cannot seem to be able to print. The nozzle of the hot end does not touch the bed and the LCD reads "heating..." without ever proceeding with any actual printing. I did not receive an end-stop to attach to the nozzle but I was ...

Hi everyone!

Firstly, thank you!

John from Geeetech was able to assist me with this, it's just a matter of downloading Arduino 1.01 and picking the correct board! I sincerely hope everyone figured it out as well and thanks again for the responses and help!!

Hello,

I have finished building and calibrating my printer but cannot seem to get the extruder-stepper motor to work. I cannot seem to be able to test it on Repetier or from the G2's LCD controls. I have had my printer for just over 2 weeks and am still unable to print.


I would really ...

Hi everyone,

I seem to be having some trouble compiling my code in ardunio, I am unfamiliar with coding so I was hoping someone here could help.
The error I receive reads as follows:

qr_solve.cpp:7:18: fatal error: time.h: No such file or directory
#include <time.h>
^
compilation terminated ...