Geeetech

well i got no errors with Arduino 1.0.1 got the frimeware upploaded but now the display only shows some rundom pixels and the X motor is "switching on and off" constantly every second
can not even connect it to the computer anymore... Money well spent

Thanks sagat, i will try 1.0.1 right away

well yes my main board is Gt2560 and i have select that in Tools/Bord: "Audrino Mega or Mega 2560"
I have select the correct port as well.

what I mean is: if you open the firmware you sent me in Arduino, click on the tab Configuration.h
you will see these options of Main Boards (See picture)
omg ...

Sorry that link does not help me, says nothing about error codes like mine " fatal error: time.h: No such file or directory
#include"

And your link says noting about setting bord in Configuration.h .... are you sure im not supose to change it to bord
34? (=RAMPS 1.3 / 1.4 (Power outputs: Extruder0 ...

Start to think i have to get a engineer degree to get this printer going?
How do i get the frikin firmware in to the printer then?
I have restarted the computer so i can connect printer in Repetier...Start Audrino 1.6.5, changed name on RKMA_GT2560_双头 folder to Marlin (get error otherwise)
i gues it ...

yeah what I can see from the instructions, the z min is between Y and Z endstop .... since the probe obviously does not work, can i change anything so I can level manually? Three weeks without a single extrusion from the printer starts to feel like a big joke :| I just want to get shit going (btw ...

yes the probe was down...
The probe connector should sit between Y and Z endstop right?

Ye it was the PSU, i had connected it wrong ... embarrassing but true :roll:
Anyway next problem, when I try to auto leveling the printer slamms extruders down the heat bed and keep on going until i emergency stop it manually?
it´s like the probe aren't even there? not responding to it... if i ...

...

Okay, after much trouble the printer is assembled ,finally
problems I encountered was;
-M6 washers between Diagonal Rods and rod-end bearingholder for Spider and Carriage was too large so I had to remove them completely,
Yes accuracy will not be good but rather that than not to move fully ...