Geeetech

THANK YOU CHRIS!!!

That was indeed the problem. I had connected the switch leads to the 2 outer positions such that when the probe was down and not in contact with the print bed it would send Triggered. This in the instructions under the Check the Status of Endstop section, step 2. But I read it ...

Re: Delta Rostock mini G2s Extruder drives Axial motors
Postby Mark » Tue Sep 08, 2015 8:34 pm

We are testing the latest firmware now, it won't take long to fix the problem, plz wait with patience, tks!

It has been 2 weeks now... any update to fix this problem?

There's a typo in my message above. It should, of course, read G29 for auto level rather than G20.\

My message was wrong. My printer is still not working using G29.

Video of failed auto level behavior posted to https://www.youtube.com/watch?v=9wMnkB3hA50

Yes, after some significant tweaking to get the bed perfectly level manually and set the printer height in firmware and Repetier (to 204.3), and editing out the G20 auto level command from the Slic3r-generated G-code I am able to print my first object successfully. Printing accuracy isn't ...

Hi there, I'm having issues with the G29 auto level command on my new system.

The behavior I see is that G29 causes the print head to descend to about 60mm above the heat bed with X slightly positive and Y at about -30mm. It moves slowly counterclockwise at that height for about 5 seconds and then ...

Thank you both Mark and Jeff for your responses.

I imagine that if the motors were incorrectly connected, then I would not be able to home the system and extrusion would not sometimes work.

I have since updated to the August 24 version of the firmware with no perceivable difference in behavior.

I ...

On my system I have completed initial build and calibration but have yet to be able to print anything.

What I observe is that, using the Repetier-Host interface, manual commands to advance extruders will occasionally cause X/Y/Z axial stepper motors to activate, driving upwards. If the system is in ...

Thanks so much!

What I could really use is the templates for top and bottom frame plates. I would like to modify to cut acrylic for a larger frame that would also accomodate a 12" non-heated plate.