Geeetech

Hello,

When attempting to print on my G2S I get the problem of the motor failing to feed. When applying a slight bit of pressure to the spring to relieve the foce on the gear it works better but I am unable to keep it in this position. Any suggestions? It is really impacting my ability to print ...

Mark wrote:You can adjust the screw of the LCD controller to see if it works.
Or you have plugged the LCD wire to the SD outlet, try to swap them .

Thank you very much, that fixed the problem

Hello all,

When I uploaded the code to my G2S all that appeared on my LCD screen was the backlight. No rectangles, no display, nothing, just the light. Any suggestions?

Regards
IdioticAussie