Geeetech

Just got my G2S->G2S Pro upgrade kit setup and my thermistor #2 is reporting 358 degrees, along with a MAXTEMP error.

Seems similar to http://www.geeetech.com/forum/viewtopic ... temp+error except I'm not showing 0/0, I'm showing 358/0

Thanks.

Thank you. I will check the output, but extruder 2 easily got to 205, and given the melting, I think extruder 1 went well above

On my G2S, I can't get extruder 1 to go above 190 degrees. Extruder 2 does.

Ideas?

----

Right as I was about to hit send, I noticed that my hot end was at an angle. I suspect my thermostat stopped working, but the heating didn't and it melted right out.

This was my first print attempt (once I ...

I'm a bit confused about the auto leveling probe. Mine doesn't seem like it could possibly do any good as it is not lower than the nozzles? Did I assemble the nozzels incorrectly?

Thank you, making the drive belt looser worked. It had been too loose originally, and I went overboard tightening it.

Freshly set up my G2S and upon home, the Z carriage moved a little then stopped. I was able to put some force upwards and have it work, but then in moving -Z 10 mm, works the first time, the second time Z only moves about 6 mm before stopping. If I keep light pressure on it, it will move with the X ...