Hello Mark,
thank you for your answers.
I think it is not just the LCD. I tried reseting it, unplugged all other stuff, checked the cable, connection, board and COM port in the Arduino IDE etc. (I´m not new to Arduino and electronics so i did normal failure search so far) In the repetier software is ...
Search found 3 matches
- Mon Oct 19, 2015 5:33 pm
- Forum: Firmware
- Topic: Can´t upload Firmware
- Replies: 13
- Views: 31143
- Mon Oct 19, 2015 5:00 pm
- Forum: Firmware
- Topic: Can´t upload Firmware
- Replies: 13
- Views: 31143
Re: Can´t upload Firmware
Sure. Nothing happens.
- Mon Oct 19, 2015 5:14 am
- Forum: Firmware
- Topic: Can´t upload Firmware
- Replies: 13
- Views: 31143
Can´t upload Firmware
Dear Geeetech,
i bought a Prusa i3 Pro X. I assembled it and it worked fine for one day. Two days later i started it again and the LCD just displays 2 rows of blocks.
I then tried to upload new Firmware as recommended in this forum. I used Arduino IDE 1.0.1 and the firmware available in this forum ...
i bought a Prusa i3 Pro X. I assembled it and it worked fine for one day. Two days later i started it again and the LCD just displays 2 rows of blocks.
I then tried to upload new Firmware as recommended in this forum. I used Arduino IDE 1.0.1 and the firmware available in this forum ...