Geeetech

When you adjust the pot do you need/want the stepper motors connected or disconnected?

Mark:

Thank you. The last item - Unchecking the Disable Motors after Job/Kill was the one that fixed my problem. I don't know how I missed that one!

Coop

I have just built the G2S Pro Rostock delta printer. I have been able to tune it enough to get reasonable prints from it. The problem I seem to be having is that when the last G-Code command gets sent from Repetier-Host software the stepper motors are all disabled which causes the hot end to fall ...

Is the GT2560 programmed as a Arduino Mega 2560 or a Sanguino?

Mark
Thank you for your reply. I searched for a plug with a cat # of DL044 and came up empty.

I did finally find the plug at Digikey Part # WM3576 (Molex part number 0873690300). Hope this helps others.

Mark
Thank you for your response, but the link that you provided points to the source code for version 1.0.3 which I indicated that I already downloaded and reviewed.

I am searching for the source for the firmware which is currently loaded on the GT2560 as it came from the factory for the Rostock ...

I have a Geeetech Rostock G2S Pro (metal) printer. I am searching for the source code for the firmware which was originally installed on the GT2560 controller when it was shipped.
Printrun reports:
"Marlin1.0.0"
echo: Last Updated: Aug 19 2015 20:41:08 Author: (Eddie, Delta)

Before I try to ...

I need to replace one of the fan plugs that plug into the GT2560 control board. Can anyone tell me what Molex part number for the 3 pin connector?

Thank you