Geeetech

Is that configuration for a "2-in-1-out" hot-end? Looking at it, it seems just like a regular hot-end configuration. Even the toolchange retraction is set at 10mm when it should not be greater than 2mm for a 2-in-1-out hot-end. Maybe you shared the wrong config file?

What is the recommended extruder feed rate/flow rate and printing speed (using 1.75mm ABS filament) for the 2-in-1-out hot-end? I can't seem to get it 100% right so far.





Thank you very much for your help!

So it is not compatible with the G2s Pro? But in the video on the hot-end's page shows what it seems like a G2s Pro using a 2-in-1 hot end. Why?

Seriously think about buying the 2-in-1out hotend , but I won't even consider doing so until I know exactly what are the Marlin Firmware's settings adjustments required to use this 2-in-1out hotend with a G2s Pro? There's not much info on it. Does it have two thermistors (one for each extruder), or ...