Homing is not yet because three axis went down when I pushed the homing button.
Thus yesterday reading Q&A of this forum, I changed part of configuration.h from 'true' to 'false' like below.
from (this is initial condition.)
#define INVERT_X_DIR true // for Mendel set to false, for Orca set to ...
Search found 2 matches
- Wed Jan 20, 2016 3:25 pm
- Forum: Stepper Motor
- Topic: All axis go to the bottom stage vertically
- Replies: 3
- Views: 5749
- Tue Jan 12, 2016 10:43 pm
- Forum: Stepper Motor
- Topic: All axis go to the bottom stage vertically
- Replies: 3
- Views: 5749
All axis go to the bottom stage vertically
I'm setting up Delta Rostock mini G2. I finished until building the machine and compiling firmware.
However, when I tried to control each axis manually and to push X positive, all axis started to move to the bottom stage at the same time.
In short, each stepping motor rotated in an only direction ...
However, when I tried to control each axis manually and to push X positive, all axis started to move to the bottom stage at the same time.
In short, each stepping motor rotated in an only direction ...