Hi,
As you are new to 3D printing, do you know this Site?
https://www.simplify3d.com/support/print-quality-troubleshooting/
There arme some generall explanations about Issues in 3D printing, even of you don't have Simplify3D.
What Printer, Host program and slicer do you use?
In the QuickStart ...
Search found 3 matches
- Mon Jan 30, 2017 4:14 am
- Forum: Print Quality
- Topic: Every print fail.
- Replies: 1
- Views: 6024
- Sun Jan 29, 2017 7:00 am
- Forum: Print Quality
- Topic: G2s Pro Mini Calibration issues
- Replies: 3
- Views: 8886
Re: G2s Pro Mini Calibration issues
Your diagonal Rods don't have the correct length.
Measure them from the middle of the screws.
If the rods have different lenghts, you have to adjust them by screw the head of the rod.
A half turn will increase or decrease the length about 0,5mm.
After every rod has the same length, you have to ...
Measure them from the middle of the screws.
If the rods have different lenghts, you have to adjust them by screw the head of the rod.
A half turn will increase or decrease the length about 0,5mm.
After every rod has the same length, you have to ...
- Sun Oct 30, 2016 10:01 pm
- Forum: Extruder
- Topic: Missing PFTE tubes?
- Replies: 4
- Views: 7742
Re: Missing PFTE tubes?
had the same Problem on My G2S Pro kit.
The PTFE tube from the Extruder Motors to the hotend fit in the threaded rod.
I cut a Piece and put it into the threaded rod.
Tip: cute the ptfe tube 1 mm longer than the threaded rod.
Why? look here.
https://www.youtube.com/watch?v=OoShQSrrYdA
The PTFE tube from the Extruder Motors to the hotend fit in the threaded rod.
I cut a Piece and put it into the threaded rod.
Tip: cute the ptfe tube 1 mm longer than the threaded rod.
Why? look here.
https://www.youtube.com/watch?v=OoShQSrrYdA