Hello,
1. i use my own M8 Rods no problem.
4. No shortet outs on the bottom side. all contacts looks good. I have tested with our own sensors and and and. one or two sensors connected it shows 358 on both. I MUST disconnect BOTH sensors and it goes down to 71 degree. Is no sensor connected and i ...
Search found 2 matches
- Mon Feb 08, 2016 3:02 am
- Forum: Firmware
- Topic: How to use ST-LINK to install firmware for GTM32
- Replies: 30
- Views: 166291
- Sun Feb 07, 2016 1:23 am
- Forum: Firmware
- Topic: How to use ST-LINK to install firmware for GTM32
- Replies: 30
- Views: 166291
Re: How to use ST-LINK to install firmware for GTM32
This printer...
1. M8 Rod too long, i must remove extruder fans.
2. X Axis no contact to the endstop, i must remove the rings from the rods.
3. X Axis movement inverted, i must set it in the LCD menu.
4. LCD show me 301° for hotend and printbed. i must disconnect BOTH and now it goes to 71°
The ...
1. M8 Rod too long, i must remove extruder fans.
2. X Axis no contact to the endstop, i must remove the rings from the rods.
3. X Axis movement inverted, i must set it in the LCD menu.
4. LCD show me 301° for hotend and printbed. i must disconnect BOTH and now it goes to 71°
The ...