Geeetech

So now I have to post another issue with this printer.

I have been able to finally print some great items with this, but had a lot of oozing. So after doing some research, I needed to do some more retraction, especially with a Bowden style printer. I got the printer up to a 10mm retraction and I ...

So I finally have a working 3d Printer!

First issues was the diagonal rods were not identical in length. I have to heat them up and adjust them to make them all the same length, then adjust the software. Second issue was a couple of bad ball bearing with the driven wheel. Once replaced, I was ...

Sorry I threw it away. It wasn't the driven wheel itself, but on of the bearings. I went to the local hobby shop and picked up a few 4mm x 8mm x 3mm bearings. It is now working much better.

First problem was the diagonal rods were different lengths. I had to heat them up and adjust them to the same ...

Aaron, I have to agree. I had to heat the rod ends up and adjust them, they were all different sizes.

Sadly I am finding quality issues with some parts are very poor. The rods were the first issue, now the ball bearings on the driver wheel are failing. I haven't been able to completely calibrate ...

I tried a different way of leveling the hot plate and I have made some progress. Using a level was not working, but letting the hot ends hit naturally on the hot bed and moving it around, then seeing where they sat on the plate helped me adjust the bed.

I also found a major problem. I found that ...

I have done all those steps and still it keeps hitting in the fourth position.

Yes. The second hot end is slightly higher than the first. In positions 1,2 and three the second hot end is still slightly higher, but in position four the second hot end is hitting the plate first and the first hot end is much higher. This is causing printing issues, since the second hot end is ...

I am having the same issue. I made a post about this also. Waiting for a reply.

I raised the second hot end up higher than the first hot end. Points 1,2 and 3 are fine, but when I get to point 4 the second hot end is hitting before the first hot end. I have tried everything.

https://lh3 ...

I have the G2S Pro with Dual Extruders and running into an issue that I have not been able to resolve since building the printer. I have done thru all the posts and emails that have been sent to me from Geeetech and haven't been able to fix the issue.

If you look at this image below, you will see ...

OK after some more reading and testing I found that the diagonal rods were different sizes. I heated one end and adjusted them to be all the same. I then changed the firmware to have the correct rod length. I then went thru the whole process of leveling, homing and adjusting again.

What I find is ...