I have a Prusa I3 Aluminum printer with Sanguinololu 1.3A controller.
I have changed the Z axis screws to a acme lead screw, instead of the stock wobbly M8X1.25
So I down loaded the Arduino IDE compiler V1.01 and the firmware Plusa I3 A sanguinololu.zip
Went in the configure.h changed the #define ...
Search found 3 matches
- Wed Apr 20, 2016 10:02 am
- Forum: Firmware
- Topic: Plusa I3 A sanguinololu.zip issus
- Replies: 1
- Views: 4380
- Thu Apr 14, 2016 8:04 am
- Forum: Stepper Motor
- Topic: X & Y Axis motors weak Zwon't turn at all
- Replies: 2
- Views: 5894
Re: X & Y Axis motors weak Zwon't turn at all
Thank you Mark no jumpers under the drive
installed the jumpers under all drives, works like it should.
installed the jumpers under all drives, works like it should.
- Mon Apr 11, 2016 11:47 pm
- Forum: Stepper Motor
- Topic: X & Y Axis motors weak Zwon't turn at all
- Replies: 2
- Views: 5894
X & Y Axis motors weak Zwon't turn at all
This is my first 3D printer it is the geeetech I3 aluminum with Sanguinololu V1.3A
I finished the build and powered it up everything seem to work. using the display control went to home
it and the X steeper motor made a loud grinding noise and was jerking trying to go to home
then the Y axis did the ...
I finished the build and powered it up everything seem to work. using the display control went to home
it and the X steeper motor made a loud grinding noise and was jerking trying to go to home
then the Y axis did the ...