Geeetech

Hello,

i think my mosfet of the heatbed is dead. It doenst heat anymore.
Since i habe the Dual Head Firmware on my M201 i can use my heatbed as second extruder and that works.
How can i fix my mosfet?

I figuered out, that the 24V fuse is dead, but i already found out which fuse to buy. Maybe you should write somewhere which fuses are used in the board, so other can find easily the right one

I solved my problem. I bought a 12V Extruder for my 24V board. I burned my fuse, replaced it and bought 24V Hotend and now everything is fine for ONE extruder. For the Dual Extruder i have to get the 1.0.5 for dual head on the M201!

I want it too!

I want it too!

Hi,
i have the same problem on my M201.
The fuse IE10A has 24V, the fuse IE15A is dead.
Where can i get them? Can you send me?

Hello,

i bought for my Prusa M201 a Mk8 Dual Extruder, I also bought the Geeetech Mk8 Dual Extruder holder

i have a few questions and problems.
1. I cant reach the x-end stop now. The extruder hits the z-rod first.
2. The nozzle is higher than the x-axis holder where the bearings are.
3. It is ...

Hello,

i have a Geeetech M201 (GTM32 Rev. B Board) and everything worked very well. Now i decided to get a MK8 Dual Extruder. I changed the thermo cable and the heating cable. Extruder heated up to 210°C and then my printer made a beep sound and shut down.
Now the printer does the following things ...

Hi,
1.I don't think the infrared thermometer can test the exact temp...But why not increase the original temp by 20 degree since you've found a 20 degree to have a try?

2.You can check if the PTFE tube was plugged deep enough,look some guys' tips in this post:
viewtopic.php?f=19&t=17372&start=20 ...

Hello,

i bought my Prusa M201 some few months ago. I enjoyed to assembe it. Everything worked fine with using Repetier Host duing manuall moves, like moving the axis, pulling filament into the extruder, heating the nozzle an bed. Then i tried to print, but never had sucess till now. I had to clean ...