Geeetech

axrael71 wrote: Sat Oct 10, 2020 3:06 am Are you ever going to implement autotune for PID on the A30?

Are you a comedian

When will simple things like this and Auto PID be available ?

I mean the Maxium Heating Temp not the PID settings

Hi

Can someone please advise me on how to adjust the Max temp in the A30 Firmware I would like to lift it up from 250
is this possible through a Gcode Command ?

BobaLives wrote: Wed Oct 02, 2019 9:51 am I thought the printer was suppose to pause and beep when the filament end went past the filament run-out...

I know this sounds like a simple question,But do you have the filament run out sensor enabled ?

front left corner has stopped sticking to the heatbed

Hi Gents & Ladies

So I have a A30 which I only purchased in July 2019 and now the Superplate is peeling up off the heatbed
Wondering if many people have had this issue and if so did they replace the Superplate or peel it off and moved on a different way ?

Have you check the Heatbed plug where it goes into the control box
My heatbed stopped working the other day and one of the pins in the plug was tight enough and had turned blue from the high resistance

Hi alex-w

I worked it out late last night
My issue was I didn't have a SD card in the side of the printer when flashing the firmware

I have has this issue when the A30 will sit in a continual restart loop when connected to a PC
the only way to stop this is to restart the printer

I decided to rerun the Firmware Tool and now I have the below error and it wont let me update the LCD Firmware
https://i.imgur.com/9pgRJIk.jpg ...