Geeetech

For the original part in this post the replacements are
The PCB Header is Molex part # 39-28-1043
And the plug is Molex part # 39-01-2040
You'll also need the crimps for the plug, 4x Molex part # 39-00-0039

I have also had to replace other parts the green connectors to the extruder(s) and hot bed ...

I may have found the correct one I will report back when they arrive and I install it.

Well I learned its a 2x2 4-pin atx 12 volt connector but without things pitch and row spacing it becomes a very difficult thing to find the exact part assuming I am just going to replace it.So I was hoping someone might have had a similar experience and could provide some insight.

In the past I have had issues with the control board and overheating problems so far as even already needing to replace the connectors to the heat bed. However the problem has move on the the next weakest point in the system and has burnt out that connector as well. So does anyone know a place I can ...