Geeetech

Hi. I'm on firmware 1.0.5 and I can't get the M106 or M107 commands to work. I'm just using the manual G-Code entry field in Repetier Host and trying the following:

M106 P0 S0

I've tried swapping P0 for P1,P2,P3,P4 but it makes no changes to any of the running fans. I've also tried M107 P0 (and P1 ...

I'm on M201 1.0.5 and one nice feature I've noticed (not sure if it was there before or not) is that once the print is finished, it sets the temperatures to 0, ejects the filament, and sends the nozzle to home.

This is great except that because it seems to do a simple XYZ home straight away, it ...

This might not be the right sub-forum to post this in, but while a print is happening, my M201 gradually reduces the FR value displayed on the LCD starting at 100% and gradually (maybe 10% in half an hour) goes down.

I just tried setting it to 120% and sure enough, everything runs 20% faster but it ...

Is there any chance the PID tuning commands will be implemented?

M301 - Set PID values
M303 - PID tuning
M500 - Save

I'm about to fit an E3D Lite6 to my M201 and therefore to the GTM32 board. Is it possible to set the thermistor type? The instructions on E3Ds page are for the various open firmware types out there: http://wiki.e3d-online.com/wiki/E3D-Lite6_Assembly#Configure_Firmware_.28Easy.21.29

I'd rather not ...

Yeah - I'm really interested in where you found this as well. I was just about to go on a search for 'regular' firmware for this since I plan to replace the mixer hotend.

This was the first stop on my Google trawling so if I find anything, I'll try to remember to report back.

Also wanted to say thanks. I'd been having flow problems too. I disassembled the hotend and pushed the PTFE through until it was flush with the vertical risers before screwing them back in.

My bed also reports temperatures 30 degrees lower than they really are. I'll sort a thermistor at some point ...

Yep. Thanks very much. I took the hotend apart again, cleaned it all out and with everything disassembled, pushed the PTFE rods through so they were flush with the bottom ends of the vertical risers that go up into the cooling block.

Flow problems seem to have been resolved. Next to sort out, Z ...

I've just finished putting together the M201 and managed to get about half a millimetre into a cube print before flow stopped from the nozzle. I've tried increasing the temperature to clear it, reducing the temperature, increasing flow rate but it was just stuck. I cannot force filament through ...