Geeetech

Added 10 to Bed left and front, 1 to Area width and depth.
If I put 160 and try to print the same size, the extruder leave the bed, but if 159 is going well, so I'm like 161 for print 160 and is ok 8-) .
The bed size is 180x180mm, setting with 160x160mm with extruder at 10x10mm into the bed, should ...

I modified some settings and works on the maximum size. But I still think it is wrong, in fact it has loaded data showed in the user manual.
But finally it works.
Thanks.

Hi,
I have an issue with the position of the piece into the bed.
It follows that the printer can’t print their max capacity because the piece to print is displaced too far to the left. Please see the picture. My printer is a Mecreator2.
What can I do for resolve this?
Thanks

Really you can do that. The board that control the fan have two connectors, one of them are always on, the other is located at the side of this, it's name is FAN_PWM, with this you can control the fan speed with manual control, and when you are printing also is controlled. I don't know if this ...

Now are printing fine, and prints super!
Thanks to all.

I inspect the voltage, and I find that the A4988 at extruder side measures 0 volt between potentiometer and GND, and 5 volt between VDD and GND. I exchange with any axis to test, and now that axis only moves in one direction. I assume that my A4988 is bad, so… I'm looking for a replacement. I am ...

I inspect the voltage, and I find that the A4988 at extruder side measures 0 volt between potentiometer and GND, and 5 volt between VDD and GND. I exchange with any axis to test, and now that axis only moves in one direction. I assume that my A4988 is bad, so… I'm looking for a replacement. I am ...

Hi,
I need help please, finally my 3D printer is working, but I have a problem with the amount of filament that is been extruded. It is not enogh. There is a significant change if I use my hand to press filament into the extruder. My 3D uses the MK8 extruder, I tried all you explain in this post ...

Thanks, I stay relaxed.

Hello everyone, I'm new here. Just get my new mecreator2, I'm still testing and trying to print ABS, PLA works very well.
My question is: Is normal that the fan extruder are always working, and alwaus in the maximum?
Thank you all.