Geeetech

No sorry, I meant Dual-head Hot End
http://www.geeetech.com/wiki/index.php/ ... ad_Hot_End
It's possible to be used on a Prusa I3 M201 already mounted? Firmware, hardware are compatible?

Thanks

Hi all,
could anybody tell me if Assembled JIETAI Dual-head Hotend could be mounted on Prusa I3 M201 and in this case what modification should be done.
If not, I need to know on what printer inside in GEEETECH stock could be mounted JIETAI Dual-head Hotend.

Thanks

Please, be serious!
What I mean has been successfully explained in preceding post, there are two point of questions.

Hi,
so I have another problem on my M201. After replacing the hot bed because the thermistor in GEEETECH hot bed was broken, I can not even print.
From the heating chamber comes out a blob in PLA, every attempt (fan, temps, unmount hot end, etc) doesn't change the result.
I'm sure it does not depend ...

Hi William,
before all thanks for reply. Then, having a look in the suggested post by Mark, my LCD has been displaying neither ERR MAXTEMP nor ERR MINTEMP.
Anyway, it shows "room temp=19/0, 0/0 ". The hot bed thermistor is open circuit, I suppose.
In this case, are we sure the board is ok? (first ...

Hi,
I need help about my Geeetech Prusa I3 M201(board GTM32) just assembled, because hot bed doesn't work.
Temperature marks always 0°, therefore bed remains cold.
I think it dipends on NTC thermistor, but after a number of attempts I don't know what else to modify.
Could somebody give me some ...