I am sorry, but the subdivision table is not clear.
I want to use DRV8825, at 1/32 step. On the table, there are 3 values
MS1 MS2 MS3 Subdivision
ON OFF ON 1/32 step
OFF ON ON 1/32 step
ON ON ON 1/32 step
Which one is the correct one ?????
Search found 3 matches
- Sun Oct 30, 2016 4:50 pm
- Forum: Stepper Motor
- Topic: Stepper Motor Drivers
- Replies: 3
- Views: 8579
- Mon Oct 03, 2016 1:31 am
- Forum: Stepper Motor
- Topic: Weak motors
- Replies: 4
- Views: 12894
Re: Weak motors
I just discovered the same !
The worst point is not to add 15$, it just to have to wait several weeks before being able to use the printer like it should have to work from day 1 !
You'd better not reduce your price and ship the printer with a bit more powerfull motors.
I understand now the source ...
The worst point is not to add 15$, it just to have to wait several weeks before being able to use the printer like it should have to work from day 1 !
You'd better not reduce your price and ship the printer with a bit more powerfull motors.
I understand now the source ...
- Sun Oct 02, 2016 10:36 pm
- Forum: Products FAQ
- Topic: Issues with a Pro B Acrylic
- Replies: 1
- Views: 4343
Issues with a Pro B Acrylic
Good afternoon.
I just finished the assembly of my I3 Pro B acrylic, and I have a lot of issues.
During the assembly, I say that my Y motor was not correctly aligned with the acrylic frame (the upper side is relly beside the arcylic, the bottom have a small gap). I was not that afraid, so I ...
I just finished the assembly of my I3 Pro B acrylic, and I have a lot of issues.
During the assembly, I say that my Y motor was not correctly aligned with the acrylic frame (the upper side is relly beside the arcylic, the bottom have a small gap). I was not that afraid, so I ...