Geeetech

Hey all.
Well they replaced the probe.
New one worked for half a calibration then the probe pin changed position(like now the self test at the start is too small to see) again. The pin has like 1mm of travel.
Now all I get is probe failed.
I specifically didn't adjust this one to make sure there ...

update! think i might have hit a bad 1... it nolonger self tests on startup. geeetech are looking at my firmware etc just now and are trying to help. will keep everyone updated

HI THERE
SORRY COULDNT GET REPLIES TO ACTUALLY POST... DONTKNOW WHATS GOING ON....
and apparently i dontknow how to switch off caps lock...
anyways. thank you for the reply. unfortunatly my issue doesnt come up there. has this happened to anyone else or is there a fix to this im missing?
thnx
Mevo

thank you for the reply. it wasnt really covered there though. the pin(and adjustment screw) lower during print. not realese of the pin the whole things moves down and has to be allen keyed back into possition

Hey all
i just installed(what a nightmare if you have repetier and no manual)
everything looked great till i noticed i couldnt set my nozzle offset. it was just never quite right. then i got a print to start after reseating everything and dismantling the probe. midway through the second layor i ...