Installing the firmware here and switch Red and orange Wire dont make any Difference.
No responce to codes
Should have bought pnp sensor.
This is really expensive and even not working.
I have Pro b version btw
Search found 3 matches
- Tue Nov 29, 2016 5:03 am
- Forum: Geeetech A20M
- Topic: 3D Touch Sensor:Auto-levelling for Geeetech 3D printer
- Replies: 326
- Views: 854325
- Mon Nov 28, 2016 4:01 am
- Forum: Geeetech A20M
- Topic: 3D Touch Sensor:Auto-levelling for Geeetech 3D printer
- Replies: 326
- Views: 854325
Re: 3D Touch Sensor:Auto-levelling for Geeetech 3D printer
Hi
Yes Did like wiki and uploaded corrected firmware.
Wire colors is connected according to manual.
The z_min input is working.
The sensor Dont respond to the gcodes at All.
Pretty Lost.
The pins Page should be updated as manual?
Tried to do it, and without.
I Will check orange wires as you say.
Yes Did like wiki and uploaded corrected firmware.
Wire colors is connected according to manual.
The z_min input is working.
The sensor Dont respond to the gcodes at All.
Pretty Lost.
The pins Page should be updated as manual?
Tried to do it, and without.
I Will check orange wires as you say.
- Sun Nov 27, 2016 3:32 pm
- Forum: Geeetech A20M
- Topic: 3D Touch Sensor:Auto-levelling for Geeetech 3D printer
- Replies: 326
- Views: 854325
Re: 3D Touch Sensor:Auto-levelling for Geeetech 3D printer
Hi
My sensor Dont react when it Touch the bed.
Also Dont respond to manual codes.
It Dont Push Out the Pin before measurement, isnt it supposed to do that.
Any suggestions how to make it stop z when Touch the bed.
My sensor Dont react when it Touch the bed.
Also Dont respond to manual codes.
It Dont Push Out the Pin before measurement, isnt it supposed to do that.
Any suggestions how to make it stop z when Touch the bed.