Thanks.
As weel, if i deconnect tube from head, the filament feed normally but there are absolutly nos reason to lost step at this case, only if motor or driver is dead.
The problem is same for both extruders.
I already check at 250°C with 2 different ABS filament, there are no benefit but i don't ...
Search found 2 matches
- Fri Nov 11, 2016 9:08 pm
- Forum: Products FAQ
- Topic: G2S - ABS many problem with extruder : forced feeding !
- Replies: 3
- Views: 6570
- Thu Nov 10, 2016 11:33 pm
- Forum: Products FAQ
- Topic: G2S - ABS many problem with extruder : forced feeding !
- Replies: 3
- Views: 6570
G2S - ABS many problem with extruder : forced feeding !
Hi everybody !
So it was nice to build, setup and print with my new G2S but i print only with ABS (i never test with PLA).
See the video : https://youtu.be/QAsRzLJ6qoA
The extruder force (clac-clac-clac, the motor lost steps) despite :
- Correct mounting, firmware and software.
- Cleaning with ...
So it was nice to build, setup and print with my new G2S but i print only with ABS (i never test with PLA).
See the video : https://youtu.be/QAsRzLJ6qoA
The extruder force (clac-clac-clac, the motor lost steps) despite :
- Correct mounting, firmware and software.
- Cleaning with ...