Geeetech

Hi all!

Actually I had to replace the Powersupply last night again, as I needed the stronger one I replaced the original one with for some other project I am working on.
So finally I just took a phase comperator to check if I wired it correctly and by accident I put it to the frame and was really ...

Hi all,

so far, it took me a while to come back with some results, I was not home for some longer time....
@Cup: thx for the Hint, I tried to set the Mix to 100/0 and so far it "works" out...
regarding the interfering signal: My friend studied electronics and together we analyzed the issue with ...

HI Cup!
Thanks first for the answer!
to 1: Printing via USB works fine so far - except if I have high power machines switching on/off. I realized that issue i.e. If I switch on my Soldering station or a hoover... but it also happened if I switch on/off the lights in the room....
I am investigating ...

Lads... all I can say: you fully understand how to drive your customers cracy.
Also It seems, that you fully understand, how to make sure, that your customers are not buying any of your Products...

Why not giving a statement? Why not telling: Sorry but we can not help in this case? At least I am ...

Update:
- Another few print attemps were failing trying different SD-Cards in both the slots
- i re-flashed Firmware 1.0.5 with no success (flashing without errors but Problem still the same)
- allways printer failed (by now 100% fail) i thougth it has failed in all possible ways so far, but I ...

OK.. about 4 Weeks ago I got an I3 M201
and to be honest: by now I regret it
I got the version with GMT32 Rev
So far I got a very few simple objects printed
I am using Repetier-host with slic3r and Cura Engine
With Cura I got the best results so far
Since 2 Days I have the problem, that printing ...