Geeetech

The following message occurs on Repetier msg board, when G29 command run by gcode


G29 Auto Bed Leveling
?Probe position out of range.
?Probe position out of range.


Instead when I send manually G28 G29 sequence, it works :shock:
I've tried also to move G28 G29 lines up or down at start of ...

@JLAR200 Download Arduino 1.0.1 and it'll works

Yes, I do confirm I've fixed Z level issue when extruders switch.
Now when I do it manually/by code with T0/T1 codes, Z levels
are right.
It's important to set corrrectly the boolean values as follows

http://i65.tinypic.com/1zn7pn9.jpg

I've restarted from beginning with firmware programming ...

Thank you Cup! After re-downloaded your suggested file RKMB_GT2560_G2S.zip,
made changes in configuration.h as suggested in http://www.geeetech.com/wiki/index.php/Delta_Rostock_mini_G2s
with more attention then first time and now extruders switching WORKS CORRECTLY ON THE ASSIGNED Z LEVEL !
In the ...

My Geeetech is G2s Pro. I've downloaded RKMB_GT2560_G2S file.

I want to retry to redownload it.

Reuploaded firmware with Arduino 1.0.1 and... nothing!! It's going on not working
with the 2nd extruder. More! I've tried to manually switch extruders with T commands
and each time I do it, spider climbs up 10mm each time when I move spider with G0 or
G1 commands. This makes me going nut.

And do we ...

Not yet! I've used Arduino 1.0.6.
Does it depends from Arduino ?!? :shock:
If you confirm, I'll try it!

[EDIT]
I've searched back in this topic, and... I realized that
I haven't payed attention enough to see your advice
about Arduino 1.0.1 (http://www.geeetech.com/forum/viewtopic.php?f=20&t=17181 ...

Hi, I'm reporting Z level issue dued to extruder switch during two colors printing in this topic
http://www.geeetech.com/forum/viewtopic.php?f=26&t=18469
Topic is referred to Geeetech G2s Pro. My printer is one like this.

I doesn't know firmware was pre-charged on MB, so
I've downloaded and ...

Additional informations ...
The problem occurs regardless whether or not I use ABL.
I also tried to apply gcode M420 (mesh smoothing) unsuccessfully.
In this video http://www.youtube.com/watch?v=yqBLLo4SWQs
published last June 11, 2016 the G2s seems to work properly (sob!).
Since that date how many ...

More discussions about T0 to T1 swithc error on
http://www.geeetech.com/forum/viewtopic ... 26&t=18469