Geeetech

there is 3 1 second bursts of orange on the led between reboots on the control board.

The print bed, started smoking then burnt out refusing to light up, which caused the printer to reboot, which got it stuck in a loop where it reboots with everything powering up for 3-5 seconds then it resets and starts over.

Tried to boot it without the print bed connected but it continues to ...

Found out what the problem was there was a short on the back of the control board, that lead to all the problems with it burning out stepper motors and wires.

Recently, whenever i use the stepper motor on the extruder it will work for 1-3 prints, figuring it might just be the controller so i tried swaping it with one for another motor, the other motor worked, but extruder motor still refused to work. So i ended up replacing the cable worked great for 2 ...

Hi does anyone else have the pin twitch from side to side when they use the M280 P0 S10 ; pushes the pin down.
Then when i try to use the M280 P0 S120 ; Self test, it just does an error til i reset it.

Any ideas what might be causing this

Some time the filament didnt come out at all while printing, othertimes its extruded but didnt stick instead picking up the previous layers creating a ball of filament on the noozle. The filament its been doing it with was 3d filaprint premium, rigid.ink and some super cheap chinese filament off ...

Had the printer about a month, its a prusa i3 B since then ive had to replace the usb cable, all the screw rods were bent, ive tried 3 different brands of filament, and only the sample one ended up working.
Since then i got a 3dtouch to help with bed leveling, just printing the holder didnt work ...