I actually, after my previous post, found out that my pin did not have a smooth surface and sometimes got stuck (blinking LED) . I removed the grub screw and the pin and then very, very carefully polished the pin.
Do not damage the heat shrink. Reassemble and it should work fine. Mine has been ...
Search found 2 matches
- Mon Jan 16, 2017 3:06 am
- Forum: Geeetech A20M
- Topic: 3D Touch Sensor:Auto-levelling for Geeetech 3D printer
- Replies: 326
- Views: 818048
- Wed Jan 11, 2017 3:50 pm
- Forum: Geeetech A20M
- Topic: 3D Touch Sensor:Auto-levelling for Geeetech 3D printer
- Replies: 326
- Views: 818048
Re: 3D Touch Sensor:Auto-levelling for Geeetech 3D printer
Having a 2nd Z_MIN sensor sounds good
I second that. Is that achievable? My 3DTouch is working fine after some initial struggles with the offset value, now I get good prints every time. I even tried the trick with a tilted bed. However, it would be nice with an additional safety end stop for Z ...
I second that. Is that achievable? My 3DTouch is working fine after some initial struggles with the offset value, now I get good prints every time. I even tried the trick with a tilted bed. However, it would be nice with an additional safety end stop for Z ...