It is hard to say... i tested a new powersupplie and the result is the same.
All leds on the boards looks good.
i checked the resitors in the Cartridge and there i get a result of 5ohm.
so i ordered now a new one... i give a reply with the result =)
Search found 3 matches
- Sat Apr 29, 2017 4:14 am
- Forum: Feedback&Suggestion
- Topic: Extruder does not reach the desired temperature
- Replies: 5
- Views: 11530
- Sat Apr 22, 2017 11:13 pm
- Forum: Feedback&Suggestion
- Topic: Extruder does not reach the desired temperature
- Replies: 5
- Views: 11530
Extruder does not reach the desired temperature
Hi,
i have a Prusa i3 b pro.
Some weeks ago i have problems with my power supply and my plug on the supply and board are a little bit melted and the board was over.
So i get a new board and powersupplie. But now i have a GT2560 Rev a+ instead of the original GT2560 Rev a.
The board was without ...
i have a Prusa i3 b pro.
Some weeks ago i have problems with my power supply and my plug on the supply and board are a little bit melted and the board was over.
So i get a new board and powersupplie. But now i have a GT2560 Rev a+ instead of the original GT2560 Rev a.
The board was without ...
- Tue Mar 21, 2017 3:53 am
- Forum: Power Supply Unit
- Topic: Power Supply Problem with Prusa i3 Pro B
- Replies: 1
- Views: 22872
Power Supply Problem with Prusa i3 Pro B
Hi,
I bought on 24.11 the printer and since then not much printed (about 1kg PLA).
I wanted to start a new print, but I could not do it successfully.
The printer was connected via USB and showed everything on the display.
The repetition software ran perfectly and could also be connected to the ...
I bought on 24.11 the printer and since then not much printed (about 1kg PLA).
I wanted to start a new print, but I could not do it successfully.
The printer was connected via USB and showed everything on the display.
The repetition software ran perfectly and could also be connected to the ...