Geeetech

William wrote:As to the bend Y rod,you can contact your seller about it.

Geeetech are the seller...!

I have been messaging and emailing for 5 days and not a single response or acknowledgement.
So much for the 'getting back to me in 24hrs'

I did a glass table test and sure enough all the rods are bent to some degree, the Y axis rods are the worst.

I did a glass table test with the rods and sure enough they are all bent to some degree, the Y rods being the worst.

In relation to your diagmostic checking, the bed travel seems consistantly tight, no free or loose travel t any point.

Ooops....sorry.
Its the hot bed axis, thats the Y axis?
Yes, it is the Y axis I should have said.

I would be happy to keep it and tinker but having paid out alot of money and receiving a defective part, I would hope they could send me the replacements or apartial refund so I can buy replacements myself.

I will give Geeetech until Monday to reply. If they don't then I will take the case up with PayPal and get it sent back.

Hi, I have messaged tech support 3 times and not had a response...!!!!
I have assembled the i3 Pro-C and find that the Z-Axis smooth rods and bearings are not allowing free movement, ( I have disconnected the belt), they seem a little tight. I can move it by hand but I can feel the tension. This is ...

Hi, I have messaged tech support 3 times and not had a response...!!!!
I have assembled the i3 Pro-C and find that the Z-Axis smooth rods and bearings are not allowing free movement, ( I have disconnected the belt), they seem a little tight. I can move it by hand but I can feel the tension. This is ...