I am very disappointed with 3D touch probe. After a big while to install it, due to bad instructions in the Geeetech manual (i.e. pin number), the probe was not working : it cames to error on power on.
New search on the net to discover the little screw to set. Nothing on this in the manual.
Now it ...
Search found 3 matches
- Sun Jul 09, 2017 4:17 am
- Forum: Geeetech A20M
- Topic: 3D Touch Sensor:Auto-levelling for Geeetech 3D printer
- Replies: 326
- Views: 813941
- Mon May 08, 2017 1:55 am
- Forum: LCD Panel
- Topic: lcd, head sensor temperature display
- Replies: 1
- Views: 5693
lcd, head sensor temperature display
Hi all,
I meet a mysterious problem with my gt2560 and ReprapDiscount smart controller.
At power on the head temperature is not displayed and show "ady./0°".
To get the right one I have to do -> prepare -> switch power off and then the temperature is displayed.
If I come back to switch power and ...
I meet a mysterious problem with my gt2560 and ReprapDiscount smart controller.
At power on the head temperature is not displayed and show "ady./0°".
To get the right one I have to do -> prepare -> switch power off and then the temperature is displayed.
If I come back to switch power and ...
- Sat May 06, 2017 11:43 pm
- Forum: LCD Panel
- Topic: Confused between different LCD2004 models
- Replies: 12
- Views: 54742
Re: Confused between different LCD2004 models
Hi,
Thanks a lot for your help.
After an half day trying to understand what's happened, your solution solve my problem in five minutes.
Now my LCD runs.
Thanks a lot for your help.
After an half day trying to understand what's happened, your solution solve my problem in five minutes.
Now my LCD runs.