Geeetech

[quote=Newopint95 post_id=81009 time=1506681658 user_id=55763]
If you use Repieter Host to connect to your printer you can just change the settings that way each time. It is much faster than using the knob or changing the firmware settings.

Why did you need to make the Y size so large?
[/quote ...

[quote=William post_id=80977 time=1506497444 user_id=51382]
Indeed, after you modify the parameter in LCD panel, you have to store the memory.
[/quote]
[quote=S2KTS post_id=80370 time=1505224953 user_id=61005]
Have you ever tried using "Store Memory" function? (which is located one step before the ...

Hello,

I wanted to know if there is a way to set the dimensions of the printer without having to do it manually everytime. Attached is a picture of what I am trying to change - I would like to be able to change Y Max without having to use the knob, as it is very slow. Is there a code for this ...

William wrote: Mon Aug 07, 2017 11:49 am We used to calibrate the lowest speed to 30 mm/s , you are just able to have a try moving less than 1 mm/s that do less harm to your printer.

How will I be able to try this? I am able to get it to about 1 mm/s but I would like to get it to be even slower. Will this harm my printer?

Hello,

I have a Prusa i3 M201 with the GTM32 Pro B board and I was wondering what the slowest travel speed that it can achieve.

Ideally, I would like for it to move less than 1 mm/s, perhaps even 1/10 mm/s if it is possible. Please let me know if you have any ideas that can assist me in making ...

I wanted to know if there was g-code to control the mix proportion of two different filaments. I am wanting to do many proportions and manually changing the ratio on the printer display panel is very tedious in this case.

If there isn't code, how can I at least store the last mix proportion setting ...

I have a Prusa i3 M201 with the GTM32 Pro B board, and I am encountering an issue where when I set the temperature and turn on the hotend (heat the extruder) the printer disconnects. The display on the printer flashes/"blinks" and then I must reset the printer. This issue persists regardless of the ...

Have you been able to get the PID tune to work on your first hot end?
A quick fix would be to tune hot end 1 and set the new PID into both hot ends.



You can try to apply the PID in the first extruder to the second extruder in order to check the PID in the second extruder working well.


I ...

I have a Prusa i3 M201 and I am currently using two extruders/heaters. The first heater works appropriately, but the second heater has a very high temperature overshoot, so much so that it damages both the heating element and the sensor (the covers wrapped around the wire have burned off).

I want ...

Hi,according to the error,It shows that your com port is wrong.Go to the Printer in EasyPrint 3D and select the correct com port,then it will be normal. 1.png

The com port is correct. I am able to control the printer up until the set temperature is reached; afterwards, the printer does not ...